H3C S5500-SI Series, Руководство по эксплуатации

Страница: 1108 / 1217

1-7
Follow the steps below to load a patch file:
To do… Use the command… Remarks
Enter system view system-view —
Load the patch file from the
flash to the memory patch area
patch load Required
Activating Patches
After you activate a patch, the patch will take effect and is in the test-run stage. After the switch is reset
or rebooted, the patch becomes invalid.
If you find that an ACTIVE patch is of some problem, you can reboot the switch to deactivate the patch,
so as to avoid a series of running faults resulting from patch error.
Follow the steps below to activate patches:
To do… Use the command… Remarks
Enter system view system-view —
Activate the specified patches patch active patch-number Required
Confirming Running Patches
After you confirm the running of a patch, the patch state becomes RUNNING, and the patch is in the
normal running stage. After the switch is reset or rebooted, the patch is still valid.
Follow the steps below to confirm the running of the patches:
To do… Use the command… Remarks
Enter system view
system-view
—
Confirm the running of the
specified patches
patch run patch-number Required
This operation is applicable to patches in the ACTIVE state only.
One-Step Patch Uninstallation
z
On a centralized device
You can use the undo patch install command to uninstall all patches. The patches then turn to the
IDLE state. This equals execution of the commands patch deactive and patch delete .
z
On a distributed device