5-26
# Create RRPP domain 1, configure VLAN 4092 as the primary control VLAN of RRPP domain 1,
and configure VLANs mapped to MSTIs 0 through 16 as the protected VLANs of RRPP domain
1.
[DeviceE] rrpp domain 1
[DeviceE-rrpp-domain1] control-vlan 4092
[DeviceE-rrpp-domain1] protected-vlan reference-instance 0 to 16
# Configure Device E as the master node of subring 2, with GigabitEthernet 1/0/1 as the
primary port and GigabitEthernet 1/0/2 as the secondary port, and enable ring 2.
[DeviceE-rrpp-domain1] ring 2 node-mode master primary-port gigabitethernet 1/0/1
secondary-port gigabitethernet 1/0/2 level 1
[DeviceE-rrpp-domain1] ring 2 enable
[DeviceE-rrpp-domain1] quit
# Enable RRPP.
[DeviceE] rrpp enable
6) Verification
After the configuration, you can use the
display
command to view RRPP configuration and
operational information on each device.
Intersecting-Ring Load Balancing Configuration Example
Networking requirements
z
Device A, Device B, Device C, Device D, and Device F constitute RRPP domain 1, and
VLAN 100 is the primary control VLAN of the RRPP domain. Device A is the master node of
the primary ring Ring 1; Device D is the transit node of the primary ring Ring 1; Device F is
the master node of the subring Ring 3; Device C is the edge node of the subring Ring 3;
Device B is the assistant-edge node of the subring Ring 3.
z
Device A, Device B, Device C, Device D, and Device E constitute RRPP domain 2, and
VLAN 105 is the primary control VLAN of the RRPP domain. Device A is the master node of
the primary ring Ring 1; Device D is the transit node of the primary ring Ring 1; Device E is
the master node of the subring Ring 2; Device C is the edge node of the subring Ring 2;
Device B is the assistant-edge node of the subring Ring 2.
z
Specify VLAN 10 as the protected VLAN of domain 1, and VLAN 20 as the protected VLAN
of domain 2. Thus, you can achieve VLAN-based load balancing on the primary ring.
z
As the edge node and assistant-edge node of subring Ring 2 is the same as those of
subring Ring 3, and the two subrings have the same SRPTs, you can add subrings Ring 2
and Ring 3 to the RRPP ring group to reduce Edge-Hello traffic.
