H3C S5120-EI Series, Руководство по эксплуатации

Страница: 63 / 1191

1-12
To do... Use the command... Remarks
Enter system view
system-view
—
Enter aggregate interface view
interface bridge-aggregation
interface-number
—
Shut down the aggregate
interface
shutdown
Required
By default, aggregate
interfaces are up.
Configuring Load Sharing for Link Aggregation Groups
Configuring Load Sharing Criteria for Link Aggregation Groups
You can determine how traffic is load-shared in a link aggregation group by configuring load sharing
criteria. The criteria can be service port numbers, IP addresses, MAC addresses, or receiving ports
carried in packets, or any combination of them.
You can configure global or group-specific load sharing criteria. A link aggregation group preferentially
uses the group-specific load sharing criteria. If no group-specific load sharing criteria is available, it
uses the global load sharing criteria.
Configuring the global link-aggregation load sharing criteria
Follow these steps to configure the global link-aggregation load sharing criteria:
To do... Use the command... Remarks
Enter system view
system-view
—
Configure the global
link-aggregation load
sharing criteria
link-aggregation load-sharing
mode
{
destination-ip
|
destination-mac
|
destination-port
|
ingress-port
|
source-ip
|
source-mac
|
source-port
} *
Required
By default, for Layer 2 traffic,
the default are the source and
destination MAC addresses of
packets; for Layer 3 traffic, the
default are the source and
destination IP addresses of
packets.