Operation Manual – MCE
H3C S3610&S5510 Series Ethernet Switches
Chapter 2 MCE Configuration
2-7
Table 2-10
Configure to use IS-IS between a MCE and a site
Operation
Command
Description
Enter system view
system-view
—
Enable IS-IS for a
VPN instance and
enter IS-IS view
isis
[
process-id
]
vpn-instance
vpn-instance-name
Required
This operation is performed on the MCE
device. As for the corresponding
configuration on the site, you can just
enable IS-IS as usual.
Note:
After enabling IS-IS for a VPN instance, you need also to configure to use IS-IS for
routing information exchange, which is described in the
IPv4 Routing
module of this
manual.
2.2.6 Configuring to Use EBGP between a MCE and a Site
1)
Configuration on the MCE device
Table 2-11
Configure an MCE device
Operation
Command
Description
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter BGP-VPN instance
view
ipv4-family
vpn-instance
vpn-instance-name
Required
Configure a CE as a VPN
peer
peer
{
group-name |
ip-address
} [
as-number
as-number
]
Required
Import routes of the local
CE
import-route
protocol
[
process-id
] [
med
med-value
|
route-policy
route-policy-name
] *
Required
The PE device must
import routes of the local
CE to the VPN routing
table in order to advertise
these routes to the remote
PE device.
Apply a filter policy to the
routes to be advertised
filter-policy
{
acl-number
|
ip-prefix
ip-prefix-name
}
export
[
direct | isis
process-id
|
ospf
process-id
|
rip
process-id
|
static
]
Optional
By default, routes to be
advertised are not filtered.
