21
3.2.2 Installing the RPS Unit on a Tabletop
If a 19-inch standard rack is not available, you
can place the RPS unit directly on a clean, stable
tabletop.
Follow these steps to install the RPS unit on a
tabletop:
Step 1: Cautiously turn the RPS unit upside down.
Then, use a piece of dry, soft cloth to remove any oil
stain or dust from the dents on the bottom of the
chassis.
Step 2: Peel off the stickers on the supplied foot
pads and paste the foot pads into the dents on the
chassis bottom.
Step 3: Turn over the RPS unit and place it on the
tabletop. Verify the stableness and good grounding of
the table.
3.3 Installation and Removal of the
Flatpack 1500
3.3.1 Handles of the Flatpack 1500
The Flatpack 1500 has two handles, which serve
two purposes:
z
For locking the RPS unit in place.
After the power module is inserted into the
chassis, it is locked in place by the handles at both
sides of the front panel. The handles must be turned
to the right position and firmly pushed into their slots.
