1
Installing the storage system on the
management node
Restrictions and guidelines
CAUTION:
•
If you cannot execute a command because of lack of permissions, add
sudo
before the
command and try again. If the issue persists, contact H3C Support.
•
Make sure the free space of the system disk is not less than 100 GB.
The storage system supports high availability management. If you deploy two management nodes
for high availability, follow these restrictions and guidelines:
•
The backup node must use the same version of storage system software as the primary node.
The installation procedure is the same for backup and primary nodes.
•
Make sure the backup node has IP addresses on the management, service, storage front-end,
and storage back-end networks.
Screenshots used in this document are for illustration only and might differ from your products.
Obtaining the installation package
Request the storage system installation package from the technical support and put the package to
your installation directory.
IMPORTANT:
If FTP is used, you must select binary mode for file transfer.
Installing the storage system on a management
node
Restrictions and guidelines
Do not perform any other operations during the installation.
Prerequisites
Make sure you have finished all preparation tasks in "
Preparing for installation and deployment
."
Procedure
1.
Log in to the management node. The default username and password are
SDS_Admin
and
Admin@123stor
, respectively. Access the installation directory of the storage system.
2.
Execute the
tar -vxmf Xxxx-xxxx.tar.gz
command to extract the package. The
installation package name is
Xxxx-xxxx.tar.gz
.
3.
Access the
product
directory, and then execute the
sudo bash install.sh
command.
4.
Read the precautions carefully, enter
yes
.
