25
Examples
# Configure the PPP address pool route as 2.2.2.2/24.
<Sysname> system-view
[Sysname] ppp ip-pool route 2.2.2.2 24
ppp lcp delay
Use
ppp lcp delay
to set the LCP negotiation delay timer.
Use
undo ppp lcp delay
to restore the default.
Syntax
ppp
lcp
delay milliseconds
undo ppp
lcp
delay
Default
PPP starts LCP negotiation immediately after the physical layer comes up.
Views
Interface view
Predefined user roles
network-admin
Parameters
milliseconds
: Specifies the LCP negotiation delay timer in the range of 1 to 10000 milliseconds.
Usage guidelines
If two ends of a PPP link vary greatly in the LCP negotiation packet processing rate, configure this
command on the end with a hi gher processing rate. The LCP negotiation delay timer prevents
frequent LCP negotiation packet retransmissions. After the physical layer comes up, PPP starts LCP
negotiation when the delay timer expires. If PPP receives LCP negotiation packets before the delay
timer expires, it starts LCP negotiation immediately.
Examples
# Set the LCP negotiation delayer timer to 130 milliseconds.
<Sysname> system-view
[Sysname] interface virtual-template 1
[Sysname-Virtual-Template1] ppp lcp delay 130
ppp lqm
Use
ppp lqm
to enable PPP link quality Monitoring (LQM) on an interface.
Use
undo ppp lqm
to disable PPP LQM on an interface.
Syntax
ppp lqm close-percentage close-percentage
[
resume-percentage
resume-percentage
]
undo ppp lqm
Default
PPP LQM is disabled on an interface.
Views
Interface view
Содержание MSR810
Страница 148: ...136 Related commands timer hold...
Страница 331: ...319 Related commands timer hold...