H3C MSR810, Справочник по командам

Страница: 352 / 389

340
Predefined user roles
network-admin
Parameters
ip
: Performs inverse address resolution for IPv4 addresses.
dlci-number
: Specifies a VC by its DLCI number. The value range for this argument is 16 to 1007. If
you do not specify a VC, all VCs on the interface and on all its subinterfaces are specified.
Usage guidelines
When Frame Relay sends data over an interface, the peer IP addresses must be mapped to the local
DLCIs. The address-to-DLCI mapping can be configured automatically through InARP or manually.
If you enable or disable InARP on a Frame Relay interface without specifying a VC, InARP is enabled
or disabled on the following VCs:
• All VCs on the Frame Relay interface.
• All VCs on each subinterface of the Frame Relay interface.
Examples
# Enable InARP on all VCs of the Frame Relay interface Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] fr inarp ip
Related commands
display fr inarp
fr inarp interval
fr inarp interval
Use
fr inarp interval
to set the InARP request interval during an InARP learning process.
Use
undo fr inarp interval
to restore the default.
Syntax
fr inarp interval interval
undo fr inarp interval
Default
The InARP request interval during an InARP learning process is 60 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval
: Specifies the InARP request interval during an InARP learning process. The value range for
this argument is 15 to 300 seconds.
Usage guidelines
The InARP request interval takes effect only when InARP is enabled.