H3C MSR810, Справочник по командам

Страница: 32 / 389

20
Use
undo ppp compression iphc rtp-connections
to restore the default.
Syntax
ppp compression iphc tcp-connections number
undo ppp compression iphc tcp-connections
Default
An interface can perform RTP header compression for a maximum of 16 connections.
Views
Interface view
Predefined user roles
network-admin
Parameters
number
: Specifies the maximum number of connections for which an interface can perform RTP
header compression. The value range for this argument is 3 to 1000:
• When the
number
argument is set to a value less than or equal to 256, packets are compressed
in the format of COMPRESSED RTP 8.
• When the
number
argument is set to a value greater than 256, packets are compressed in the
format of COMPRESSED RTP 16.
Usage guidelines
RTP is a connection-oriented protocol. An interface can accommodate multiple RTP connections.
RTP header compression occupies memory resources for maintaining connection information. This
command can limit memory resources used by compression. For example, if you set the limit to 3,
RTP header compression only applies to a maximum of three RTP connections.
After you execute this command, you must shut down and then bring up the interface to make the
command take effect.
You can configure this command only when IPHC is enabled. The configuration is removed after
IPHC is disabled.
Examples
# Set the maximum number of connections for which Serial 2/1/0 can perform RTP header
compression to 10.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] ppp compression iphc enable
[Sysname-Serial2/1/0] ppp compression iphc rtp-connections 10
Related commands
ppp compression iphc enable
ppp compression iphc tcp-connections
Use
ppp compression iphc tcp-connections
to set the maximum number of connections for which
an interface can perform TCP header compression.
Use
undo ppp compression iphc tcp-connections
to restore the default.
Syntax
ppp compression iphc tcp-connections number