H3C MSR810, Справочник по командам

Страница: 192 / 389

180
Examples
# Set the type of number and numbering plan identification both to unknown for the calling numbers
in incoming ISDN calls on BRI 2/4/0.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn number-property 0 calling in
# Set the type of number and numbering plan identification both to unknown for the called numbers in
outgoing ISDN calls on BRI 2/4/0.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn number-property 0 called out
isdn overlap-sending
Use
isdn overlap-sending
to enable overlap sending on an ISDN interface for called numbers.
Use
undo isdn overlap-sending
to restore the default.
Syntax
isdn overlap-sending
[
digits
]
undo isdn overlap-sending
Default
En-bloc sending is enabled for called numbers. In the SETUP message, ISDN includes all
information required by the network to process the call.
Views
ISDN interface view
Predefined user roles
network-admin
Parameters
digits
: Specifies the maximum number of digits that can be sent in each SETUP message. The value
range is 1 to 15, and the default is 10.
Usage guidelines
In overlap mode, called number information is absent or incomplete in each outgoing SETUP
message.
Overlap sending is not available in ANSI, DSS1, ETSI, NI, or QSIG.
You can execute the command only when no call is present on the ISDN interface.
Examples
# Enable overlap sending on B RI 2/4/0, and c onfigure the interface to send a m aximum of 12
called-number digits in each SETUP message.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn overlap-sending 12
isdn pri-slipwnd-size
Use
isdn pri-slipwnd-size
to set the sliding window size on an ISDN PRI interface.