138
Parameters
bundle-id
: Specifies an HDLC link bundle by its number in the range of 1 to 10.
Usage guidelines
An interface can be the member of only one HDLC link bundle. To move an interface from one HDLC
link bundle to another HDLC link bundle, remove the interface from the current HDLC link bundle
first.
You must enable HDLC encapsulation on an interface to be assigned to an HDLC link bundle. You
cannot change the link layer protocol encapsulation of an HDLC link bundle member interface.
You can assign interfaces to an HDLC link bundle before you create the HDLC link bundle.
Examples
# Assign POS 2/2/0 to HDLC link bundle 1.
<Sysname> system-view
[Sysname] interface pos 2/2/0
[Sysname-Pos2/2/0] bundle id 1
bundle load-balance
Use
bundle load-balance
to set the load balancing mode for an HDLC link bundle interface.
Use
undo bundle load-balance
to restore the default.
Syntax
bundle load-balance
{
per-flow
|
per-packet
}
undo bundle load-balance
Default
Per-packet load balancing is used.
Views
HDLC link bundle interface view
Predefined user roles
network-admin
Parameters
per-flow
: Specifies per-flow load balancing.
per-packet
: Specifies per-packet load balancing.
Usage guidelines
The following load balancing modes are available:
•
Per-flow load balancing
—Forwards packets of the same flow out of the same Selected
interface. A flow is identified by match criteria.
For IPv4 and IPv6 packets, the match criteria include source IP address and destination IP
address.
For MPLS packets, the match criteria are MPLS labels.
•
Per-packet load balancing
—Distributes packets evenly across all Selected interfaces by
using the round-robin method.
Examples
# Set per-flow load balancing mode for HDLC link bundle interface 1.
<Sysname> system-view
Содержание MSR810
Страница 148: ...136 Related commands timer hold...
Страница 331: ...319 Related commands timer hold...