89
Syntax
stp transmit-limit limit
undo stp transmit-limit
Default
The maximum transmission rate of all ports is 10. Each port can send up to 10 BPDUs within each
hello time.
Views
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
limit
: Sets the maximum number of BPDUs the ports can send within each hello time. The value
range is 1 to 255.
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
Command compatibility in Layer 2
aggregate interface view
MSR800 Yes
MSR 900
No
MSR900-E Yes
MSR 930
Yes
MSR 20-1X
No
MSR 20
No
MSR 30
Yes
MSR 50
Yes
MSR 2600
Yes
MSR3600-51F Yes
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in port group view, the setting takes effect on all member ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate
interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port
leaves the aggregation group.
A larger maximum transmission rate value requires more system resources. An appropriate
maximum transmission rate setting can prevent spanning tree protocols from using excessive
bandwidth resources during network topology changes. H3C recommends that you use the default
value.
Examples
# Set the maximum transmission rate of port Ethernet 1/1 to 5.
<Sysname> system-view
[Sysname] interface ethernet 1/1