212
Configuring IPv6 address assignment
Use one of the following methods to configure IPv6 address assignment:
•
Configure a static IPv6 address binding in an address pool:
If you bind a DUID and an IAID to an IPv6 address, the DUID and IAID in a request must match
those in the binding before the DHCPv6 server can assign the IPv6 address to the requesting client.
If you only bind a DUID to an IPv6 address, the DUID in a request must match the DUID in the
binding before the DHCPv6 server can assign the IPv6 address to the requesting client.
•
Specify a subnet and address ranges in an address pool:
{
Non-temporary address assignment
—The server selects addresses from the non-temporary
address range specified by the
address range
command. If no non-temporary address range is
specified, the server selects addresses on the subnet specified by the
network
command.
{
Temporary address assignment
—The server selects addresses from the temporary address
range specified by the
temporary address range
command. If no temporary address range is
specified in the address pool, the DHCPv6 server cannot assign temporary addresses to clients.
Configuration guidelines
•
You can specify only one non-temporary address range and one temporary address range in an
address pool.
•
The address ranges specified by the
address range
and
temporary address range
commands must
be on the subnet specified by the
network
command. Otherwise, the addresses are unassignable.
•
Only one prefix pool can be applied to an address pool. You can apply a prefix pool that has not
been created to an address pool. The setting takes effect after the prefix pool is created.
•
An IPv6 address can be bound to only one DHCPv6 client. You cannot modify bindings that have
been created. To change the binding for a DHCPv6 client, you must delete the existing binding first.
•
Only one subnet can be specified in an address pool. If you use the
network
command multiple
times in a DHCPv6 address pool, the new configuration overwrites the old one. If the new
configuration has the same subnet as but different preferred lifetime and valid lifetime from the
previous configuration, the new preferred lifetime and valid lifetime are effective only to the IPv6
addresses not assigned to DHCPv6 clients.
Configuration procedure
To configure IPv6 address assignment:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
Содержание MSR 2600 Series
