H3C MS4600 Series, Справочник по командам

Страница: 24 / 43

18
# Save the configuration so the IRF port settings can take effect after the device reboots.
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
flash:/startup.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait............................
Saved the current configuration to mainboard device successfully.
# Activate the IRF port.
[Sysname] irf-port-configuration active
mad arp enable
Use
mad arp enable
to enable ARP MAD.
Use
undo mad arp enable
to disable ARP MAD.
Syntax
mad arp enable
undo mad arp enable
Default
ARP MAD is disabled.
Views
Management Ethernet interface view
VLAN interface view
Predefined user roles
network-admin
Usage guidelines
Do not configure ARP MAD together with LACP MAD or BFD MAD, because they handle collisions
differently.
When you configure ARP MAD on a VLAN interface, follow these restrictions and guidelines:
Category Restrictions and guidelines
ARP MAD VLAN
•
Do not enable ARP MAD on VLAN-interface 1.
•
If you are using an intermediate device, perform the following tasks:

On the IRF fabric and the intermediate device, create a VLAN for
ARP MAD.

On the IRF fabric and the intermediate device, assign the ports of
ARP MAD links to the ARP MAD VLAN.

On the IRF fabric, create a VLAN interface for the ARP MAD VLAN.
•
As a best practice, do not use the ARP MAD VLAN for any other
purposes.