9
2.
Type a name, H3C in this example, for the new connection in the
Name
field and
click
OK
. The
Connect To
dialog box appears.
3.
Using the
Connect using
drop-down list, select the serial port to which the console
cable is actually connected. Click
OK
.
4.
Set serial port parameters. To use the default settings, click
Restore Defaults
.
5.
Click
OK
. The
HyperTerminal
window appears.
6.
Set HyperTerminal properties. In the HyperTerminal window, choose
File
>
Properties
from the menu, and select the
Settings
tab to enter the properties setting dialog
box. Select
VT100
or
Auto detect
from the
Emulation
drop-down list, and click
OK
to
return to the HyperTerminal window.
Starting up the LSQM1WCMB0
Before starting up the access controller module, verify that:
The power cables and ground cable are correctly connected.
The power outlet voltage meets the voltage requirement of the switch.
The console cable is correctly connected, the console terminal or PC is running,
and the terminal parameters are properly set.
Powering on the access controller module
After power-on of the LSQM1WCMB0, the console terminal displays the following
instruction:
Press Ctrl+B to enter extend boot menu...
1.
To enter the BootWare main menu, press
Ctrl + B
within five seconds. If you perform
no operation or press a key other than
Ctrl + B
, after five seconds, the system starts
the auto boot process.
2.
When you are prompted to press
Enter
, the autoboot is completed. Press
Enter
. The
following prompt appears:
<H3C>
This means that the LSQM1WCMB0 is ready to configure.
3.
During the startup process, the CPLD is automatically upgraded to the latest
version. After the upgrade process, the system displays “The board cpld update
successfully, please repower device.” At this prompt, power off and restart the
device so that the new CPLD version takes effect.
The LSQM1WCMB0 access controller module provides many command views. For
detailed descriptions about the configuration commands and the CLI, see
H3C WX
