H3C H3C S7500E-X, Руководство по настройке

Страница: 43 / 290

30
Step Command Remarks
2.
Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view.
interface route-aggregation
interface-number
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
3.
Exit to system view.
quit
N/A
4.
Assign an interface to the
specified Layer 3
aggregation group.
a.
Enter Layer 3 Ethernet
interface view:
interface interface-type
interface-number
b.
Assign the interface to
the specified Layer 3
aggregation group:
port link-aggregation
group number
Repeat these two substeps to
assign more Layer 3 Ethernet
interfaces to the aggregation
group.
5.
(Optional.) Set the port
priority for the interface.
link-aggregation port-priority
port-priority
The default port priority of an
interface is 32768.
Configuring a dynamic aggregation group
To guarantee a successful dynamic aggregation, make sure the peer ports of the ports aggregated at
one end are also aggregated. The two ends can automatically negotiate the aggregation state of
each member port.
Configuring a Layer 2 dynamic aggregation group
Step Command Remarks
1.
Enter system view.
system-view
N/A
2.
Set the system LACP
priority.
lacp system-priority
system-priority
By default, the system LACP
priority is 32768.
Changing the system LACP
priority might affect the
aggregation states of the ports in
a dynamic aggregation group.
3.
Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view.
interface bridge-aggregation
interface-number
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
4.
Configure the aggregation
group to operate in dynamic
mode.
link-aggregation mode
dynamic
By default, an aggregation group
operates in static mode.
5.
Exit to system view.
quit
N/A