H3C H3C S7500E-X, Руководство по настройке

Страница: 190 / 290

177
Step Command Remarks
2.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
3.
Configure an MVRP
registration mode.
mvrp registration
{
fixed
|
forbidden
|
normal
}
Optional.
The default setting is normal
registration mode.
Configuring MRP timers
To avoid frequent VLAN registrations and deregistrations, use the same MRP timers throughout the
network.
Each port maintains its own Periodic, Join, and LeaveAll timers, and each attribute of a port
maintains a Leave timer.
To configure MRP timers:
Step Command Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
3.
Configure the LeaveAll timer.
mrp timer leaveall timer-value
Optional.
The default setting is 1000
centiseconds.
4.
Configure the Join timer.
mrp timer join timer-value
Optional.
The default setting is 20
centiseconds.
5.
Configure the Leave timer.
mrp timer leave
timer-value
Optional.
The default setting is 60
centiseconds.
6.
Configure the Periodic timer.
mrp timer periodic timer-value
Optional.
The default setting is 100
centiseconds.
You can restore the Periodic timer
to the default at any time.
Table 14 shows the value ranges for Join, Leave, and LeaveAll timers and their dependencies.
•
If you set a timer to a value beyond the allowed value range, your configuration fails. You can
set a timer by tuning the value of any other timer. The value of each timer must be an integer
multiple of 20 centiseconds and in the range defined in
Table 14 .
•
As a best practice, restore the timers in the order of Join, Leave, and LeaveAll.