Manual Version:5PW100-20120627
5
antenna pattern will be degraded on the building or tower side. Typically, the higher an antenna is
above the ground, the better it performs. Install the antenna vertically and mount it as high as possible.
Keep the antenna away from metal obstructions and wire mesh.
Choosing a mounting location
The ANT-2506V-M6-E is typically installed on a high position, such as tower or building roof, with a mast.
The higher an antenna is above the floor, the better it performs. If possible, use a cable as short as
possible to connect the antenna and AP.
Mounting the antenna
You can install the ANT-2506V-M6-E antenna on a mast. The installation accessories are provided
(installation tools are user provided). If you intend to install your antenna on another surface, you must
provide the appropriate installation accessories.
Tools and equipment required
Provided with the antenna:
•
Four M8 hex nuts that have been attached to the antenna
•
Two U-bolts
•
Four M8 hex nuts
•
Eight 8 mm (0.32 in) flat washers
•
Eight 8 mm (0.32 in) spring washers
•
One L-mounting bracket
•
Two U-mounting brackets
User-supplied:
•
One adjustable wrench
•
One knife
•
A cable tie
•
Grounding cable
•
Sealant tape and sealing clay
•
One mast with a diameter of 40 to 80 mm (1.57 to 3.15 in)
Mounting the antenna on a mast
To mount the antenna on a mast:
1.
Use four sets of M8 hex nuts, spring washers, and flat washers to attach the L-mounting bracket to
the antenna bottom.