3
Black 120V-277V
White- Neutral
Green- Ground
Rear Panel
Housing
Figure 3
(Note 2)
(Note 1)
(Note 2)
}
LED Array
LED Array
(See above)
1. For wall mount, secure backplate to junction box (screws provided with junction box), and feed input source
wires through center hole in rear panel. Note: this unit has a wide input range, 120V-277V, eliminating the
need for special wiring based on the input voltage.
2. Connect input power leads (120V-277V) to black lead from unit; neutral to white lead and ground to green
lead. Once all connections have been made, feed all wires and wire nuts through the center knockout of the
rear panel into the junction box.
NOTE: For wall switch functionality, refer to Section 5 for wiring details.
3. For conduit mounting, remove NPT ½" (refer to Figure 3A), feed input source wires through the conduit and
opening in rear panel into the unit. Secure the conduit to the rear panel then connect input power leads per
step 2 above.
For conduit mounting (Note 3):
Step 2: Remove NPT ½" Pipe
Plug from top of unit to allow
for conduit installation with
input source wires.
Step 1: Remove Screw and washer
from inside of the rear panel.
Figure 3A
SECTION 3: LUMINAIRE WITH AC ONLY OPERATION WIRING INSTRUCTION
