CLEANING
1. Turn off all switches located at the
top rear of the unit
2. Close the water intake valve.
3. Unplug the power cord.
4.
Completely drain water from the unit.
Caution: Water may be HOT!
5.
Unscrew the back two screws
indicated below, and remove the top
plastic cover.
6.
Under the plastic cover, you'll locate
the cooling tank as illustrated above.
7. Remove the top cover of the cooling
tank, as illustrated above.
8.Gently yet throughly wipe out the
inside of the cooling tank with a clean
cloth. Do not use any soap or other
detergent.
9.
Secure the top cover of the cooling
tank, back in place.
10.
Place the plastic cover back in place,
and screw in the 2 screws.
If the HOT WATER POWER was turned on
before completing the steps on page 3, it is
likely the hot water safety feature has been
triggered, and the hot water heating is disabled.
To reset the Hot Water please complete the
following steps:
II
e.) Place the lower front panel back on the unit
WATER RESET
Hot water
reset switch
a.)
Please disconnect the
electricity, and make sure all
power switches are OFF
b.)
Locate the "Hot Water
Reset Switch" by looking at
the back of the unit through
the cooling grate as
pictured to the left.
c.)
Remove the lower front
panel as pictured to the left,
and reach in and up with
your hand to feel for the
switch.
d.)
Press the Hot Water
Reset Switch.
f.)
Please follow the set-up steps on page 3, and ensure there is water in the hot
tank before turning the power switches back on.
�
H 2 0 - 5 0 0 B O T T L E L E S S W A T E R C O O L E R I N S T A L L A T I O N & O W N E R S M A N U A L
Pure n Natural Systems, Inc. | purennatural.com | 1-800-237-9199
