GYS GYSPOT Combi 230 Pro, Руководство пользователя, Страница: 10 / 32

10
A- Steel position (fig.I)
Connect the machine to an appropriate power supply
Connect guns with its connectors.
Nb: Combi 230 Pro has, in addition to the power connector, a connector to command the torch
trigger:
-
Connect the latter if you wish to start by using the trigger.
-
Disconnect it if you prefer use the generator with automatic start (see OPERATION
section).
Press the « on/off » key (
⑥
).
The indicators switch on for few seconds then the machine displays:
•
①
Tool, n°1 by default, (star welding or dent pulling clamp).
•
②
Power level, n°5 by default, (setting adapted for 0.8mm steel sheets).
To change the power level, press the + or – keys (
③
). Keep the desired key pressed to scroll through the levels
automatically.
The available power levels allow the straightening of sheets of varying thickness (fig I-2).
To change the tool used with the gun, press the tool selection key (
④
).
The tool indicator will blink for 5 seconds. During this time, it is possible to change the tool number by pressing
the + or - keys (
③
).
Available Tools (fig I-3)
1
Straightening using the star hammer,
or dent pulling clamp.
5
Welding rivets for side rods
2
Crimped welding wire or rings for straightening
6
Welding rings for fixing vehicle body.
3
Impact reduction with specific copper tip
7
Welding studs for vehicle body and connecting beams
4
Carbon electrode for tempering