MOVEHEAD FIXTURE USER MANUAL
Page 4
Chapter 2 Panel operation
1.
Brief
The light panel diagram show as Figure 3, above area is fixture description, below area show
fixture real-time status, such as DMX cable status, lamp status, error or information(ps. when
there are message haven’t been checked, echo ’ERR’ in status bar, otherwise echo ‘NOR’).
Display & operation just like ‘Android operation system’, when select or set item value, system
save the setting immediately.
RDM protocol is embed in fixture, user set DMX address via cable using the controller support
RDM function. when fixture was search by controller, display will echo ‘RDM’ indicate this RDM
is work.
Figure 3 Panel diagram
2.
Operation
1. Operate fixture with touch or encoder/button
The left area is TFT Display and touch(product which support touch), chick item or value
with finger will to complete operation of set light setting(parameters) or view light state.
The area on the right hand side is rotary encoder with button or key, As auxiliary input
interface, if fixture disable touch function, the encoder/key can been choose to set or view the
item, and then press the encoder button/key to confirm the selection, rotary encoder or push
key again set the parameter value, finally, Press encoder button/key one again to save value
or setting.
2. Parameter value setting
When the selected item is value need to been modified, the dialog shown in Figure 4 will pop up.