GDM-8352 User Manual
68
Compare Measurement
Compare measurement checks to see if the measurement data stays
between a specified upper (high) and lower (low) limit.
Applicable
measurements
The compare function can be used with the
following basic measurement functions:
ACV, DCV, ACI, DCI, Ω, Hz/
P, TEMP,
Procedure
1.
Press SHIFT
→
HOLD(COMP).
2.
The high limit setting appears.
Use the Left and Right arrow keys to navigate
to the digit to be edited, or to select the decimal
point.
Use the Up and Down arrow keys to edit the
selected digit, or to place the position of the
decimal point.
V
3.
Press the Enter key to save the high limit setting
and automatically go on to the low limit setting.
4.
Enter the low limit setting in the same fashion
as the high setting.
5.
Press the Enter key to confirm the low limit
settings.
6.
The compare measurement results will appear
immediately:
If the current measurement reading is between
