Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
WARNING Keep all objects at least 1 metre from
the front, sides and rear of the appliance.
PLEASE NOTE: As this product is fitted with a
Timer, the Timer has been set to the
“ON”
position. Please refer to the Timer section for
setting instructions.
ASSEMBLY OF THE HEATER
Turn the heater upside-down on a non-scratching
and stable surface. Be careful to prevent damage
to the paint finish or your floor surfacing.
Fit the wheel castors onto the radiator by placing
the U-shaped bolts between the outermost fins on
each side of the radiator. Screw the wing nuts onto
the U-shaped bolt and fasten the wing nut securely.
HEAT CONTROL SWITCH
The control switch positions are:
I
- Low heat
II
- Medium heat
III - High heat
Check that the Heat Control Switch is set to Off
position before plugging the heater into the mains
supply. For greater economy, use the High Heat
setting initially and then switch to the Low Heat
setting.
THERMOSTAT
Turn the thermostat knob clockwise until the
maximum
temperature
is
obtained
on
the
graduated
scale.
When
the
desired
room
temperature is reached, slowly turn the knob anti-
clockwise until the heater turns off (you will hear a
click). The heater will now cycle on and off to
maintain the set temperature.
TURBO/CERAMIC HEATER
The Turbo function is for supplying heat instantly
whilst the main heater warms up. For Turbo heat,
switch the Turbo ON/OFF using the switch on the
front of the turbo cover.
Do not use this heater with a programmer, remote-
control system , separate timer or any other device
that switches the heater on automatically.
CAUTION: The heater generates heat during use.
Proper precautions must be taken to prevent the
risk of burns, scalds, fires or other damage to
persons.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
IMPORTANT! NEVER COVER THIS HEATER!
SAFETY DEVICE
This appliance has three protection devices:
The first device will automatically turn the appliance
off if the appliance is not in the appropriate
operating position.
The second device automatically disconnects &
reconnects the appliance at a pre-set temperature.
The
third
device
disconnects
the
appliance
permanently in case of overheating, by means of a
thermal fuse (it is non resettable).
Operating Your Oil Column Heater
