9
Basic Set Up
Connecting the water supply hose
1. To prevent leakage from the
connection joints, ensure the rubber
washer seals are fitted to each end
of the water supply hose. Do not use
without the seals in place.
2. Fit the straight end of the water supply
hose to the cold water tap.
3. Connect the angled end of the hose to the water inlet valve on
the machine. Hand tighten the plastic parts of the connections.
If you are unsure, please call a qualified plumber for safer
connections.
4. Open the tap slowly and check that there are no leaks around
the connection joints.
Points to remember
• Follow the instructions in this section to avoid water leaks.
• Don’t connect the hose to a combination tap.
• Don’t twist, squash, modify or cut the hose.
• This machine is designed to connect to the cold water supply. Do not connect to the
hot water supply.
• Use only the new water supply hose supplied. Old hose sets should not be reused.
Water drain hose
Points to remember:
• Don’t twist, pull out or bend the drain hose.
• Your washing machine should be no more than 85 cm from the drain outlet.
• The water drain hose should be mounted at a height of minimum 60 cm, maximum
100 cm from the ground.
• Before connecting to the waste pipe, make sure to check the waste pipe and remove
any stopper or blockage inside, otherwise the unit may not be able to expel the waste
water properly.
3/4”
3/4”
