GUSMER GX-8, Руководство по эксплуатации, Страница: 12 / 32

Model GX-8 Spray Gun
12 32943-1, Issue 1
OPERATION
WARNING: N
EVER POINT THE GUN AT OR NEAR OTHER PERSONNEL OR PLACE ANY PART OF
THE BODY IN THE PATH OF THE MATERIAL SPRAY AND
DO NOT
AT ANY TIME LOOK INTO THE
DISPENSING END OF THE GUN
. W
HEN THE GUN IS NOT BEING USED
,
ALWAYS SET THE REAR
STOP TO THE SAFETY OR SERVICE POSITION
,
AND CLOSE BOTH MANUAL VALVES
. D
O THIS TO
AVOID THE POSSIBILITY OF PROPERTY DAMAGE OR BODILY INJURY FROM THE ACCIDENTAL
OPERATION OF THE GUN
.
Safety Position of Gun
The GX-8 has a two position Safety Stop. When engaged, it prevents accidental
triggering of the gun during servicing or down time. When disengaged, it allows the gun
to dispense.
1. ENGAGE THE SAFETY STOP-
Push in and turn the Safety Stop knob
clockwise to place the gun in the
Safety detented position.
IMPORTANT: Always engage the
Safety Stop when the gun is not in use.
Figure 7. Engage the Safety Stop
2. DISENGAGE THE SAFETY STOP-
Push in and turn the Safety Stop knob
counterclockwise to place the gun in
the Open detented position.
Figure 8. Disengage the Safety Stop
Manual valves
TOOLS REQUIRED
•
5/16” Spintite (P/N 0904A)
The GX-8 Coupling Block is equipped with
two Manual Valves which control the flow
of each chemical component to the gun.
1. OPEN BOTH MANUAL VALVES-
Using the 5/16” Spintite, turn each
Manual Valve fully counterclockwise.
NOTE:
Unnecessary triggering of the gun
with the manual valves closed
may cause crossover if there is
any residual chemical in the gun
ports.
2. CLOSE BOTH MANUAL VALVES-
Using the 5/16” Spintite, turn each
Manual Valve fully clockwise.
Figure 9. Manual Valves