Model GX-7-DI Spray Gun
10
22943-1, Issue 1
IMPORTANT: To avoid accidental gun operation determine that the coupling block
manual valves have been closed before attempting to service the gun, or any time the
gun is not in use.
Air Line Configuration
TOOLS REQUIRED
•
3/16” Hex Key
•
6” Adjustable Wrench
Figure 8. Air Line Configuration
The GX-7-DI air line connection can be configured in two different ways: The standard
configuration has the air connection at the base of the handle. The optional configuration
has the air connection at the rear of the gun. To change to the optional configuration
proceed as follows:
1.
REMOVE THE 4“ LONG PIPE NIPPLE- Using the 6” Adjustable Wrench, remove
the 4“ long pipe nipple from the base of the Gun.
2.
REMOVE THE 1/8” PIPE PLUG- Using the 3/16” Hex Key, remove the 1/8” pipe
plug from the rear of the gun.
3.
INSTALL THE 1/8” PIPE PLUG- Using the 3/16” Hex Key, install the 1/8” pipe
plug in the location previously occupied by the 4“ long pipe nipple.
4.
INSTALL THE (OPTIONAL) SUPPLIED BRASS 1/8” NIPPLE- Using the 6”
Adjustable Wrench, install the supplied brass 1/8” nipple in the location previously
occupied by the 1/8” pipe plug.
IMPORTANT: If your gun was received with the Mixing Module and Pattern
Control Disc (PCD) installed, proceed to Start-Up. If your gun was received without
the Mixing Module and PCD installed, proceed to Mixing Module and PCD
Installation.
