Model GX-7-DI Spray Gun
18
22943-1, Issue 1
Centerline Component Installation
TOOLS REQUIRED
•
3/8” Open-End Wrench
•
1/2” Open-End Wrench
•
5/8” Open-End Wrench
•
3/16” Hex Key
•
5/16” Spintite
The Centerline Components consist of the following:
Figure 11. Centerline Component Installation
1.
INSTALL THE VALVING ROD- Connect the Valving Rod to the Rod Draw Bar
and insert it into the Air Cylinder. Using the 5/16” Spintite, thread the assembly into
the End Cap until approximately 3/16” to 1/4” of thread is protruding from the end
of the Piston Rod.
2.
INSTALL THE LOCK NUT- By hand, thread the Lock Nut on to the Valving Rod.
3.
INSTALL THE GUN BLOCK- Carefully slide the Gun Block onto the Valving Rod
towards the Air Cylinder. Using the 3/16” Hex Key, install the Gun Block onto the
Gun Block Mounting Bracket.
4.
CONNECT THE AIR SUPPLY- Connect the Air Hose to the Quick Disconnect
Fitting on the Air Supply Hose.
5.
INSTALL THE MIXING MODULE- Depress the Gun Trigger Lever and slide the
Mixing Module over the end of the Valving Rod while making sure its alignment pin
enters the alignment slot in the Gun Block. Keep the Gun Trigger Lever depressed
and proceed to Step 6.
