Guntermann & Drunck DVI-Vision-IP, Инструкция по установке и эксплуатации

Страница: 91 / 148

Establishing a KVM-over-IP™ connection for the first time
G&D DVI-Vision-IP · 14
English
Establishing a KVM-over-IP™
connection for the first time
G&D’s KVM-over-IP™ technology makes it possible to transmit signals between the
computer and the user module using a Gigabit Ethernet (layer 3).
The communication between two modules requires various settings. In the default
settings, the modules are configured in a way that a computer and a user module
can immediately establish a direct connection.
All computer modules are preconfigured with the IP address 172.17.0.10 , all user
modules with the IP address 172.17.0.11 .
Default setting of the modules
The default setting of the modules allows users to quickly establish a direct connec-
tion between a computer and a user module. The OSD lets you adjust the configura-
tion of both modules after their initial operation.
Both the IP addresses and the KVM-over-IP settings are preconfigured as follows:
IMPORTANT:
If you use the KVM extender as a matrix module with the IP matrix
switch ControlCenter IP , you can conveniently set up the KVM-over-IP™ connection via
the web application of the IP matrix switch (see instructions for the web application
of the IP matrix switch ).
Manual configuration as described in this chapter is not necessary in this case.
IMPORTANT:
Change the default IP addresses before integrating several computer
or user modules into the productive network.
ADVICE: If you do not know the IP address of an already configured user or com-
puter module, it can be determined via the log messages of the device. For more
information, see the section Determining network settings via service port on page 59.
ADVICE: You can restore the default settings using the front panel of each module.
For this, follow the instructions given under Resetting the default settings on page 24.
DEFAULT SETTING OF THE COMPUTER MODULE (CPU)
IP address: 172.17.0.10
Netmask 255.255.0.0
Control port: 18246
Communication port: 18245
Data port: 18244