Guntermann & Drunck DVI-Vision-IP, Инструкция по установке и эксплуатации

Страница: 87 / 148

Installation
G&D DVI-Vision-IP · 10
English
Installing user modules
The remote console is connected to the DVI-Vision-IP-CON user module. The com-
puter connected to the computer module can be operated from this console.
Establishing a connection to a local management network
Network Management: Insert a category 5 twisted pair cable (or better), which is availa-
ble as accessory. Connect the other end of the cable to the local network.
Connecting keyboard and mouse of consoles
Keyb./Mouse: Connect the mouse and/or the keyboard of the console to this interface.
Generic:
In the default settings, you can use this interface to connect another USB
input device or a supported display or tablet.
Activate the
generic HID
mode (see
Selecting the USB-HID mode
on page 45) if you want
to connect another USB input device. In this mode, any data of the USB input device
is
not altered
when transmitted to the computer module.
Mouse:
Connect the PS/2 mouse of the console.
Keyb.: Connect the PS/2 keyboard of the console.
NOTE:
If desired, connect this network interface to a local network. This enables
you to access the Config Panel web application from this network and to send sys-
log messages to this network.
NOTE: Both the keyboard and the mouse of the console can either be PS/2 or USB
devices.
IMPORTANT: If the generic HID mode is active, the OSD cannot be operated by a
keyboard connected to the Generic socket.