GUDEL NGHP Series, Руководство по обслуживанию

Страница: 50 / 146

Set the planetary gearbox NGHP as follows:
Prerequisite:The planetary gearbox has been pre-assembled
Ü 2
48
Prerequisite:The planetary gearbox is blocked
Ü 2
42
Prerequisite:Also use the following values table according to the size you
use.
1 Rotate the planetary gear counter-clockwise to mounting position 30°
2 Tighten the screws by hand
The planetary gear NGHP has to be secured against turning
3 Measure linear system backlash
Use suitable measuring device
3.1 Push and measure carriage against the left side of the tooth flank
3.2 Push and measure carriage against the right side of the tooth flank
4 Determine theoretical operating position by table or GAdjuster from
Güdel
5 Set the planetary gear to the determined value
6 Check linear system backlash
6.1 If there are deviations:
Repeat process from step 3
7 Tighten the screws by hand
7.1 The planetary gear NGHP has to be secured against turning
8 Tighten screws with a torque wrench
The planetary gearbox NGHP has been set.
Value table size
80
Planetary gear
NGHP 080
Pinion Z20-M2H Z16-M2.5H
Precision class P1 P3 P5 P1 P3 P5
Minimum setting
value [µm] 13 24 35 13 24 35
Table 6-2 Dimension example NGHP 080
Commissioning
SERVICE MANUAL Planetary gear Güdel NRH, NRHP,
NGHP
18014399245011339_v2.0_
EN-US
50