GUDEL FlexxPump4 B, Руководство по эксплуатации

Страница: 49 / 157

5.5 Initial commissioning
Check the connections of the hydraulic system before starting up the prod-
uct.
5.5.1 Switch on the FlexxPump
2 x
On
OFF
On
60 s
On
Fig. 5-8 Switch on the FlexxPump
Switch on the FlexxPump as follows:
Prerequisite: The FlexxPump is switched "OFF"
1 Touch the active surface with the magnetic peg
Ü 2
37
2 Remove the magnetic peg from the active surface once the LCD displays
"On" and the yellow LED lights up
3 Wait until the green LED and the LCD flash twice
If no error is detected, "On" is displayed on the LCD and the green LED lights
up every 60 s.
The FlexxPump is switched on and ready for operation.
The FlexxPump lubricates according to the stored settings.
5.5.2 Execute FIL menu
The FIL menu is used to trigger a defined multi-dispensing action. The func-
tion enables, for example, connected components (lubricating lines, Y-seg-
ments, splitters) to be pre-filled with lubricant for the initial commissioning.
40 pump strokes are initiated with the activation. The function can be inter-
rupted manually at any point.
The function is only available if the FlexxPump is switched "On". The control
system reverts to "On" mode after a completed function.
Commissioning OPERATING MANUAL FlexxPump4 B lubrication system
3421295627_v1.0_
EN-US
49