Guardian Telecom AS12, Инструкция по установке и эксплуатации

Страница: 7 / 12

Guardian Telecom Inc.
Installation and Operation
Model AS12
Page 7
Installing the AS12

Inspect the product for shipping damage.
Tip: If the product is damaged,
notify the carrier immediately.

Do not open or attempt to open the AS12 unit. There are no user
serviceable parts inside the unit.
Tip: Unauthorized modifications
void the product warranty.

Carefully plan input and output connections.
o
Identify input and output devices.
o
Prioritize amplifier inputs. Channel #1 is the highest priority. If
more than one amplifier fails at the same time, the standby
amplifier will only replace the highest priority, the lowest numbered
amplifier.
Tip: Familiarize yourself with
unit capabilities and functions.
See: Block Diagram and Unit
Operation details.

Choose a location on a standard 19" equipment rack with three rack
units (3U) of available space.
See: Specifications for overall
dimensions.

Do not apply power to the AS12 before connecting input and output
devices.

Ensure all devices that will be connected to the AS12 are turned off.

Follow all appropriate electrical codes for the installation.

Use the following sequence when wiring connections:
o
Audio Inputs
See: Connection Details,
below.
o
Control Logic Inputs
o
Remove quick disconnect connector (Phoenix Combi-Con).
o
Wire the connector.
o
Plug the connector back into the unit.

Connect input power to a 120 volt AC power source.
Tip: 240 volt AC input power is
available as an option.

After all connections are complete, apply power to the AS12.

Apply power to all input devices.
See: Connection Details and
Unit Operation, below.
Connection Details
See: Block Diagram.

Connect Audio Inputs and Outputs to the Combi-Con connector as
follows:
Tip: The maximum switching
capacity of each circuit is 325
watts using a 70V paging line.
o
Terminal #1 – 70V/100V Audio Out Hot Lead (to Speaker).
o
Terminal #2 – 70V/100V Audio Out Common (to Speaker).
Tip: Terminal #1 is the left
terminal viewed from the wire
side.
o
Terminal #3 – 70V/100V Audio In Hot Lead (Amplifier Output).
o
Terminal #4 – 70V/100V Audio In Common Lead (Amplifier Output).
o
VOX Logic Input – Cable supplied with DA388
Tip: DB9 connector
o
Amp Failure Logic Output – For remote indications of faults.