GTS DWG (BL) 13/7-2 ZE, Инструкция по установке и эксплуатации

Страница: 38 / 88

Issue 07/2011 Page 38
Bu
ilt
-in g
en
er
at
or
s w
ith s
w
itch c
ab
in
et f
or p
er
m
an
en
tly i
ns
ta
lle
d p
ow
er g
en
er
at
io
n s
ys
te
m
s ≥ 1
2 k
VA i
n fi
re e
ng
in
es
Installation of generator
Installation of generators of model 132
3.5.4 Assembly instructions for hydraulic drive
Preparatory disassembly
>
Unscrew two M8 x 45 screws, wrench size 10 mm, (figure 6 [2] ). Remove the
sleeve [1] .
>
Unscrew and remove four screws M12 x 12 [3] , along with the washers.
1
2
4x
3
Figure 6 Preparatory disassembly for flange mounting in case of
hydraulic drive (generator model 132)
Assembly
> Place the flange (Figure 7 [2] ) onto the generator.
> Place a toothed washer [4b] underneath the four screws [4a] and secure
with Loctite.
> Place toothed washers [3b] underneath the nuts [3a] .
> Place the collar [1] and clamp securely with two screws.
> Mount the first half of the coupling [5] on the shaft at the generator and
prevent it from twisting on the shaft using with a key.