FST 75/150
260-2210-002 EN064
Page 11 / 37
Rotary switch – How it works
The rotary switch has two functions. By turning the knob to the left or right, you will be able to retrieve the
menu items (segment display), and by pressing the knob, you can confirm your selection.
The following list shows the main and sub-menus which have been assigned a Number ical code or to a
display. By setting the Number ical code and then pressing the button, you will switch to the sub-menus and
back again.
The means of programming is always the same:
1.
Switching on program mode:
Hold down the rotary switch for 3 secs. The main menu will be
displayed (flashing).
2.
Selecting the main menu:
Turn the knob to set the relevant Number ical code and then press to
switch to the pertinent sub-menu
3.
Setting functions:
Make the relevant settings by turning to the pertinent Number ical code and
press to select. The display will switch to the main menu.
4.
Quit program mode: Turn the rotary switch
until the figure 00 appears in the display and then
press the rotary switch.
Number codes – Menu structure
Explanations:
Certain menu items are only available in connection with the respective components. When using a DES
other menus automatically become activated.
There are 3 types of menu structures:
a) As a rule, following a main menu will be a sub-menu which contains a variety of selection options.
Example:
Main menu 21 Function contact edge
Sub-menus 1 to 3 for selection options
b) A main and sub-menu can also consist of a main menu and a setting parameter.
Example:
Main menu 23 Auto time lock
Sub-menu 0…99 Setting the time (see below)
c) Having selected a main menu, you will need to run a start.
Example:
Main menu 11 Correct end position
Sub-menu -.- Command to run start
Please note:
The positions marked with a "(W)" have been configured as factory default settings.
A 3-digit number will be displayed when changing the display from hundreds digits to tens digits.
