GST GST102A, Инструкция по установке и эксплуатации

Страница: 13 / 43

GST102A/GST104A/GST108A/GST116A
Conventional Fire Alarm Control Panel
Installation and Operation Manual
Page
8
➢ ENTER: It is available in Access Level II for confirmation.
 Keys with LEDs
➢ EVAC: It is available in Access Level II. Pressing this key can start all sounders for
evacuation and the LED illuminates yellow steadily. Press key again to cancel.
➢ DISABLE/ENABLE: It is available in Access Level II. Pressing this key can disable
or enable an output or a zone and the LED illuminates yellow steadily.
➢ OUTPUT PROGRAM: It is available in Access Level III. Pressing this key can set
output program and the LED illuminates yellow steadily.
➢ TEST: It is available in Access Level II. Pressing this key can set test status and the
LED illuminates yellow steadily.
 Control Lock
➢ CONTROL ENABLE: If it’s switched to the “OFF” position, the CIE is at the access
level 1. If it’s switched to the “ON” position, the CIE is at the access level 2. The 003
key is not removable in access level 2
1.4
Configuration and Functions
1.4.1
Internal Components
The internal construction of the CIE cabinets is shown in Fig. 1-2.
Fig. 1-2
○
1 Display board
○
2 Optional relay board or zone extension board for 16 zone panel
○
3 Control board
○
4 Batteries
1.4.2
Configuration and Functions of GST-116A .
GST-116A control panels have the following configuration and functions.
 Batteries: Standby power source for the CIE.
 Control board: For controlling power supply, charger, and all outputs such as
fault/disable/supervisory relay output, alarm output, sounder outputs and repeater panel
for zone 1 to 8, and monitoring the state of zone 1 to 8.
 Extension board: Providing detection input and repeater output for zone 9 to 16.
4 3 2 1