- 16 -
HDMT 263, HDMT 265
fine-tuning corrections.
• Press the
button to select the fine-tuning submenu.
• Use
to fine-tune the output channel (
63
…
-64
).
• Press
to return to the channel setting.
• Press the
M
button.
—> The "Compare/adjust the HF output level of the channel strips" – "
OUT-
PUT Level
" menu is activated.
c
ompare
/
adjust
the
hf
output
level
of
the
channel
strIps
Bx 1A
Level
0 dB
OUTPUT
• Use a test receiver to measure the output level of both channel strips and
make note of the value.
•
Use the
buttons to balance the higher output level of the one channel
strip to the lower output level of the other channel strip ("
0 dB
" … "
–7 dB
").
• Press the
M
button.
—> The "Setting the bandwidth" – "
BANDWIDTH
" menu is activated.
b
andwIdth
In this menu, you can set the output signal bandwidth.
When converting from ...
… VHF channels into VHF channels of other frequencies, set the bandwidth to
7 MHz,
… UHF channels into VHF channels, set the bandwidth to 8 MHz.
Bx 1A
8 MHz
BANDWIDTH
•
Press
to set the bandwidth.
