GSS HDMC 1000 MPTS, Руководство по сборке

Страница: 30 / 42

- 30 - PCIM 1000
—> The menu "Input channel / Input frequency" – " INPUT " is activated.
i
nPut Channel
/ i
nPut frequenCy
In this menu you have to set the corresponding input channel / input frequency
for the transponder to be received.
Bx 4A /B
C55 746.00
INPUT
OK
• Use the buttons to position the cursor under the digit to be set for
the input channel / input frequency then use to set the desired input
channel / input frequency.
—> Once the RF receiver has synchronised to the input signal, "OK" is
displayed.
—> If "– –" appears in the second line of the display, there is no input
signal present. Check the configuration of the antenna system and the
head-end station as well as the preceding settings of the cassette.
• Press the button.
—> The "Station filter" – " PROGRAM " menu is activated.
s
tation filter
The default setting for the station filter is " off ". In this menu you define the
services received to be transmitted. If services are activated the output data
rate increases.
If the station filter is switched off (factory default) all services of the transport
stream passes the station filter.
The figure of the menu below is dependent on the setting of the "Input signal
path" "INROUTE" menu (page 24).
The programming procedure shown below corresponds to the setting
"
A+B+ASI = 1 ASI = 2 ".
With this setting the transport stream of channel strip "
B
" is routed to the trans-
port stream of channel strip " A " and therefore cannot be set in channel strip
"
B
". Programming channel strip "
B
" the transport stream coming from the ASI
input can be processed only.