GSM Burglar, Руководство пользователя

Страница: 5 / 18

- 4 -
Voice prompt The function and status of the prompt voice
Power LED Light up and "AC
adaptor" icon display
on LCD
Panel power is normal
Light up and "battery"
icon display on LCD Alarm panel external power disconnect, using battery
Is off Alarm panel without power supply
ARM LED Light up and "STAY
ARM" icon display on
LCD Alarm panel at STAY ARM state
Long light up and "
ARM" icon display on
LCD Alarm panel at ALL ARM state
Flashing Is changing to the DELAY ARM
Is off Alarm panel at DISARM
ALARM LED Light Alarming, LCD display specific information
Flashing Is changing to the DELAY ALARM
Status LED Light Panel at the configuration mode
Flashing Panel at the enquiry mode
Display on
LCD the GSM
Signal,
SIM
card Status
“ GSM Signal
"flashing
Searching GSM Signal
“ GSM Signal " light GSM Good signal
“ SIM Card " not light Indicates that no plug SIM Card
“ SIM Card " light SIM Card loaded correctly
3.1 Alarm Panel Initial Setup
Load the SIM Card, fix the GSM Antenna, connect the power and other cables if any, then power up
alarm panel. The alarm panel voice prompt "Welcome to use alarm system", and start self-test the GSM
network, LCD shows "GSM signal" flashing while searching GSM Signal (it takes about 10 seconds or
so for searching). "GSM signal" light means GSM signals and SIM card are normal.
Upon everything working properly, the battery switch should be at the [ON] position for continuous
charging.