Page 2 of 4
Unit 2, 110 Station Rd, Seven Hills ,NSW, 2147, Australia
Traveller Series
240VAC Sine Wave Power Inverter
Operating Instructions
Please read these instructions before use
1.
Controls and indicators:
The POWER switch turns the control circuit in the power inverter on and off. It does not disconnect power from the power
inverter.
To turn ON: Press the power button 3-5 seconds then the inverter will start.
2.
Input Voltage Indication:
By default this enabled and is indicated by the “Input(V)” LED being lit. If the unit is in “Output Wattage(%)” Mode, press
the POWER button once to toggle to Input Voltage.
When in Input Voltage mode it will display on the three digit display a reading of the battery voltage.
3.
Output Wattage
:
The “Output Wattage(%)” LED indicates that the display now reads the Output Wattage being consumed represented as
a percentage of the maximum opperating wattage.
To toggle the display to this mode, Press the POWER button once quickly.
Installation
1.
Where to install
- The power inverter should be installed in a location that meets the following requirements:
Dry
– Do not allow water to drip or splash on the inverter and in an area free of salt or moisture-laden air.
Temperature – Ambient air temperature should be between 0º and 40º.
Ventilation
– Allow at least twenty-five millimeters / one inch of clearance around the inverter for airflow. Ensure the
ventilation openings on the rear and bottom of the unit are not obstructed. The installation site should not be susceptible
to temperatures in excess of 50ºC.
Safety
– Do not install in a battery compartment or other areas where flammable fumes may exist, such as fuel storage
or engine compartments.
Dust-free
– Do not install the inverter in an environment where there are dust, wood particles, metal filings and
shavings. These can be pulled into the unit blocking the cooling fans.
Close to battery / batteries
– Avoid excessive cable lengths (Mount the inverter between one and two metres from
the batteries) but do not install the inverter over or in the same compartment as batteries. Use the recommended wire
lengths and sizes. Do not mount the inverter where it will be exposed to the gases produced by the battery. These gases
are very corrosive and prolonged exposure will damage the inverter.
SWB240R-R2
Model:
SWB1000-12, SWB1000-24
SWB1800-12, SWB1800-24
SWB2500-12, SWB2500-24
Front view, main functions & Operation:
