Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
Controls and indicators:
1.
ON/OFF Switch (all models):
The ON/OFF switch turns the control circuit in the power inverter on and off. It does not
disconnect power from the power inverter. Always leave this switch in the off position before
operating inverter.
2.
Over temp LED indicator (all models):
The over temp LED indicates that the power inverter has shut down because it has become
overheated. The power inverter may overheat because it has been operated at power levels
above it’s rating, or because it has been installed in a location, which does not allow it to
dissipate heat properly. The power inverter will restart automatically once it has cooled off.
3.
Overload LED indicator (all models):
The overload LED indicates that the power inverter has shut itself down because its output
circuit has been short-circuited or drastically overloaded. Switch the ON/OFF switch to OFF,
correct the fault condition, and then switch the ON/OFF switch back to ON.
4.
Input voltage display (INV1000/1500/2500 only):
This bar graph displays the status of the input voltage from the supply source. Under normal
operating conditions the bar graph should display in the green area. Should the voltage either
increase or decrease the bar graph will display in the red areas and the unit will shut down.
5.
AC Load display (INV1000/1500/ 2500 only):
This bar graph displays the AC power drawn from the power inverter. It indicates the load in
Watts. Under normal operating conditions the bar graph should display in the green or orange
bars of the display. If the load is excessive the number of bars being displayed will increase.
Should all the bars illuminate, the unit will shut down to protect itself as this is in
overload condition.
WARNING! Shock Hazard!
Before proceeding further, ensure that the Inverter is NOT connected to any Batteries,
and that all wiring is disconnected from any electrical Sources. Do not connect the output
Terminals of the Inverter to an incoming AC source.
Electrical Requirements:
Before installing your inverter, please make sure that you have appropriately sized batteries. A
battery that is too small in capacity will not allow the inverter to perform to its full specification.
The DC cabling must be connected to the correct polarity terminals of the battery bank. (Red
= Positive, Black = Negative). DO NOT extend the DC cable length to the inverter unless you
are prepared to increase the diameter of the cable. If this is necessary consult your supplier or
installer for advice.
WARNING!
Reverse polarity connection will blow the internal fuse and may damage the inverter
permanently. Reverse polarity is not covered by warranty.
Page 2 of 4
Models:
INV600-12, INV600-24
INV1000-12, INV1500-24,
INV1500-12, INV2500-24,
INV2500-12
Modified Sine Wave
DC to 240VAC Power Inverters
12VD
Operating Instructions
Please read these instructions before use
INV12-24-ALL-R1
