CHAPTER 6 SERIES & PARALLEL OPERATION
27
CHAPTER 6 SERIES & PARALLEL OPERATION
6-1. USE FOR SERIES CONNECTION
6-1-1. Series Operation Wiring:
PR/PD can be operated in series by using the maximum of two units with the same model to obtain a higher output
voltage. However, to avoid causing damages, the total voltage should be lower than 600 Vdc.
6-1-2. The wiring method below:
(1) Slave:
Connect Pin#1 of “series in” to MASTER output "+".
Connect
Pin#2 of “series in” to MASTER output "-".
(2
) If there is no series circuit board, follow the wiring method below to connect analog programming ports in each
DC power:
6-1-3. Before turning on the power
please follow the wiring diagram to connect the output terminal of the DC power supply to the load. Also connect the
related “series in” (for series use) and remote sense connectors (+S/-S).
Fig.6-1. (without remote compensation)
Series Mode Wiring Instructions
Fig 6-2. (with remote compensation)
Series Mode Wiring Instructions
