GSi PNEG-2309, Инструкция по установке и эксплуатации

Страница: 36 / 58

Chapter 4: Mixer Assembly
Installing the Motor Mounts and Motors
1. Install the left and right angle supports (37 and 38) to the gear reducer (33) using the existing
5/8" x 2" hex bolts (3), 5/8" flat washers (15), 5/8" lock washer (17) and 5/8" hex nut (22).
Figure 4-13 Installing the angle supports to the reducer
3 5/8" x 2" hex bolt 33 Reducer
15
5/8" flat washer (S-7400)
37
Left angle support
17
5/8" lock washer (S-3208)
38
Right angle support
22
5/8" hex nut (S-7363)
2. Align the slots in the base plate (39) with the holes in the angle supports (37 and 38) and install
using 5/8" x 2" HHCS bolts (6), 5/8" flat washers (15), 5/8" lock washer (17) and 5/8" hex nut (22).
Figure 4-14 Installing the base plate to the angle supports
6
5/8" x 2" HHCS bolt (S-20143)
37
Left angle support
15
5/8" flat washer (S-7400)
38
Right angle support
17
5/8" lock washer (S-3208)
39
Base plate
22
5/8" hex nut (S-7363)
36 PNEG-2309 Horizontal Fertilizer Mixer