GSi PNEG-2309, Инструкция по установке и эксплуатации

Страница: 34 / 58

Chapter 4: Mixer Assembly
Installing the Torque Arm and Turnbuckles
1. Install the torque arm adapter plates (35) to the gear reducers (33) using the existing 5/8" x 2" hex
bolts (3), 5/8" flat washers (15), 5/8" lock washer (17) and 5/8" hex nut (22).
NOTE: For 4-Ton mixer: Attach the adapter plates (35) to the two holes in the bottom corner of the
reducer (33).
2. Install one end of the torque arm assembly (36) between the adapter plates (35) and the other to the
tub (27) using 1" hex bolts (4 or 5), 1" lock washer (19) and 1" hex nut (24).
NOTE: Use 1" x 3-1/2" hex bolt (4) to connect the torque arm assembly (36) with the adapter plates
(35) and 1" x 5" hex bolt (5) to connect the torque arm assembly (36) with the tub (27).
3. Tighten the torque arm (61) by turning the turnbuckle (62). Make sure the reducer is positioned
correctly.
NOTE: The torque arms (61) are not equally centered in the turnbuckle (62). The bottom torque arm
(61) is extended farther into the turnbuckle (62) than the top torque arm (61) to provide
clearance between the jam nut and the adapter plates.
Figure 4-11 Installing the torque arm assembly (4-Ton mixer)
3 5/8" x 2" hex bolt 24
1" hex nut (S-240)
4 1" x 3-1/2" hex bolt 27 Tub
5 1" x 5" hex bolt 33 Reducer
15
5/8" flat washer (S-7400)
35
Adapter plate
17
5/8" lock washer (S-3208)
36
Torque arm assembly
19 1" lock washer 61
Torque arm
22
5/8" hex nut (S-7363)
62 Turnbuckle
34 PNEG-2309 Horizontal Fertilizer Mixer