Hui Zhou Gaoshengda Technology Co., LTD
WXT2AM2101
PAGE 7 OF 4
Version 1.0
Wifi 6E:
Antenna No.
Frequency Band
Antenna Type
Max Antenna Gain (dBi)
1
5925 ~ 7125
PIFA
4
2
5925 ~ 7125
PIFA
4
The antenna is permanently attached, can’t be repla
ced.
Notice to OEM integrator
Must use the device only in host devices that meet the FCC/ISED RF exposure category of mobile, which means the
device is installed and used at distances of at least 20cm from persons.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The end user manual shall include FCC Part 15 /ISED RSS GEN compliance statements related to the transmitter as
show in this manual(FCC/ICanada statement).
According to FCC Part 15 Subpart C Section 15.212, the radio elements of the modular transmitter must have the
radio frequency circuitry shielded. However, due to there is no shielded for this Module, this module is granted as a
Limited Modular Approval. When this Module is installed into the end product, a Class II Permissive Change or a New
FCC ID submission is required to ensure the full compliance of FCC relevant requirements.
Host manufacturer is strongly recommended to confirm compliance with FCC/ISED requirements for the transmitter
when the module is installed in the host.
The use condition limitations extend to professional users, then instructions must state that this information also
extends to the host manufacturer’s instruction manual.
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting
condition or different operational conditions for a stand-alone modular transmitter in a host, host manufacturer
have to consult with module manufacturer for the installation method in end system.
Any company of the host device which install this modular should perform the test of radiated &
condicted emission and spurious emission etc. according to FCC Part 15C: 15.247 and 15.209 &
15.207, 15B class B requirement, only if the test result comply with FCC part 15C: 15.247 and
15.209 & 15.207, 15B class B requirement. Then the host can be sold legally.
This modular transmitter is only FCC authorized for the specific rule parts ( 47CFR Part 15.247
and 15.407) listed on the grant, and that the host product manufacturer is responsible for
compliance to any other FCC rules that apply to the host not covered by the modular transmitter
grant of certification.
Host manufacturer is strongly recommended to confirm compliance with FCC/ISED
requirements for the transmitter when the module is installed in the host.
Must have on the host device a label showing Contains FCC ID:2AC23-WXT2A and IC:12290A- WXT2A
Installer should put it in the manual
：
The device for operation in the band 5150
–
5250 MHz is only for indoor use to reduce the potential for harmful
interference to co-channel mobile satellite systems
