Clear
Tubing
Pump
Barbed
Fitting
Cu
ts i
n An
y Direc
tion
Instructions
Gryphon Diamond Wire Saw model Omni-2 Plus+
• Always wear eye protection •
• Do not run blade dry- use plenty of water •
• Keep fingers clear of moving parts •
• Do not operate with finger guard removed •
• Do not operate with front cover removed •
• Unplug saw when changing blades or guides •
Important - Fill Base completely with water before use
Front
Cover
Motor Housing
Motor
Switch
Light
Switch
Upper
Blade Guide
Base
Platform
Finger Guard
Tubing
Vertical
Shafts
Blade
Chuck
Connecting
Rod
Aluminum
Block
Lower
Wrist
Pin
Upper
Wrist
Pin
Gryphon Wire Saw Parts Identification
Motor Assembly
Assembly Step 1
Place motor assembly on top of base. Slip a plastic washer onto each of the two
plastic thumbscrews found in your parts bag. Insert thumbscrews into blue
vibration grommets at the upper outside corners of the housing. Tighten screws
into motor assembly snug tight only (do not overtighten in order to minimize
vibration).
Base of saw viewed from above
Upper Housing with Cover removed
Right side of assembled saw
