Grundig GWN 48430 CW, Руководство пользователя

Страница: 12 / 48

12 / EN
Washing Machine / User‘s Manual
3 Installation
Refer to the nearest Authorised Service Agent
for installation of the product. To make the
product ready for use, review the information
in the user manual and make sure that the
electricity, tap water supply and water
drainage systems are appropriate before
calling the Authorized Service Agent. If
they are not, call a qualified technician and
plumber to have any necessary arrangements
carried out.
C
Preparation of the location and electrical,
tap water and waste water installations
at the place of installation is under
customer's responsibility.
B
WARNING:
Installation and
electrical connections of the product must
be carried out by the Authorized Service
Agent. Manufacturer shall not be held
liable for damages that may arise from
procedures carried out by unauthorized
persons.
A
WARNING:
Prior to installation,
visually check if the product has any
defects on it. If so, do not have it
installed. Damaged products cause risks
for your safety.
C
Make sure that the water inlet and
discharge hoses as well as the power
cable are not folded, pinched or crushed
while pushing the product into its place
after installation or cleaning procedures.
3.1 Appropriate
installation location
ƒ • Place the machine on a rigid floor. Do
not place it on a long pile rug or similar
surfaces.
ƒ • Total weight of the washing machine and
the dryer -with full load- when they are
placed on top of each other reaches to
approx. 180 kilograms. Place the product
on a solid and flat floor that has sufficient
load carrying capacity!
ƒ
• Do not place the product on the power
cable.
ƒ
• Do not install the product at places where
temperature may fall below 0ºC.
ƒ
• Place the product at least 1 cm away from
the edges of other furniture.
3.2 Removing packaging
reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove the
packaging reinforcement by pulling the ribbon.
3.3 Removing the
transportation locks
A
WARNING:
Do not remove the
transportation locks before taking out the
packaging reinforcement.
A
WARNING:
Remove the
transportation safety bolts before
operating the washing machine!
Otherwise, the product will be damaged.
ƒ
1 . Loosen all the bolts with a suitable spanner
until they rotate freely
(C)
.
ƒ
2 . Remove transportation safety bolts by
turning them gently.