Grundig GW781041FW, Руководство пользователя

Страница: 37 / 48

37 / EN
Washing Machine / User Manual
If the product fails to drain water inside it, the pump filter is clogged. Filter must be cleaned whenever it is
clogged or in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the product (e.g., when moving to another house) water should be drained
completely.
WARNING:
Foreign substances left in the pump filter may damage your product or may cause noise problem.
In regions where freezing is possible, the tap must be closed, system hose must be removed and the water inside the
product must be drained when the product is not in use.
After each use, turn off the tap to which the mains hose is connected.
In order to clean the dirty filter and drain the water:
1 Unplug the product to cut off the supply power.
A
Temperature of the water inside the product may rise up to 90 ºC. To avoid the risk of scalding, clean the filter after the
water inside the product is cooled down.
2 Open the filter cover.
3 Follow the below procedures in order to drain water.
If the product has an emergency water draining hose, in order to drain the water:
a Pull the emergency draining hose out from its seat.
b Place a large container at the end of the hose. Drain the water into the container by pulling out the plug
at the end of the hose. When the container is full, block the inlet of the hose by replacing the plug. After
the container is emptied, repeat the above procedure to drain the water in the product completely.
c When draining of water is finished, close the end by the plug again and fix the hose in its place.
d Turn and remove the pump filter.
4 Clean any residues inside the filter as well as fibres, if any, around the pump impeller region.
5 Replace the filter.
6 If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and then press the upper part to close.