Grundig GSS STC 160, Инструкция по сборке, Страница: 12 / 24

- 12 - STC 160
4.4 i
nstallinG
f
ter minals
Fig. 10
• Insert the required number of standard F terminals in the openings pro-
vided (knock-outs) in the front (page 7, fig. 2,
4
) and/or rear panel (page
8, fig. 4, 6 ).
Caution
Tighten the nuts until the teeth on the lock washers have penetrated the exterior
coating and a good connection is made between the housing and F terminals.
4.5 i
nstallinG an additional fan
If environmental conditions require the use of an additional fan, one can be
screwed to the inside of the base plate (hole spacing: 82 x 82 mm).
82 mm
82 mm
Fig. 11
• Remove base plate (page 10).
• Mount the fan (12 V / 1 A max.) in position
1
or
2
(fig. 11) to the
inside of the base plate with screws.
• Make the electrical connection as shown in fig. 12.