Grundig GSS SID 162 A, Инструкция по сборке

Страница: 8 / 11

- 8 - SID 162 A
5 C
onneCting the
sat if
input distributor
5.1 C
onneCting the
rf
ConneCtions
• Connect the outputs E and F to the appropriate inputs of the modules.
u
sing one reCeption area
(
loop
-
through mode
)
• Connect input D of the SAT IF input distributor to one of the pre-installed
F terminals in the rear wall of the head-end station using a RF cable made
on-site (length approx. 30 cm).
• Connect the loop-through output
C
to input
B
using a RF cable made on-
site.
u
sing t wo reCeption areas
• Connect inputs
B
and
D
of the SAT IF input distributor to the appropriate
pre-installed F terminals in the rear wall of the head-end station using RF
cables made on-site (length approx. 30 cm).
• Terminate the loop-through output C with the terminator supplied.
5.2 C
onneCting the power supply
• Connect the plug of the cable of the power connection
A
to one of the
contacts for LNB power supply of the head-end station.
Therefore observe the assembly instructions of the corresponding head-end
station.
E
A
B
D
C
F
1…3 dB 2…4 dB
0 dB